Binder for pre-folded bias tape bernette b33_b35

25,22  (190,02 kn) sa PDV

Dostupno za isporuku odmah

šifra: 5020601369
Binder attachment
for pre-folded bias tape
za bernette b33/b35

The binder attachment creates practical edge finishes with unfolded
bias tape in a width of 25 to 28 mm.
Self-cut bias tape can also be used
for a professional look.

Switch off the machine. Attach the foot as described
in the instruction manual.

Binding edges with bias binding

Stitch type: straight stitch (alternative: narrow zigzag)
Stitch length: 2 – 2.5 mm (or as required)
Needle position: centre
Feed dog: raised

Prefolded bias binding
It is possible to use bias binding with a width
of 10-14 mm (final width 5-7 mm).
Non-prefolded bias binding
It is possible to use bias binding with a width
of 23 mm (final width 5-7 mm).

Cut the bias binding diagonally at the start,
insert into the guide of the binder, and if necessary
push it through the hole with a needle or a pair of
small scissors. Guide the bias binding
backwards under the foot.
Insert the edge of the fabric to be bound into the guide
between the binding.
If necessary, the needle position or the position of
the guide channel can be
adjusted by loosening the screw so to allow
the bias binding to be sewn o
n close to the edge. Sew on the bias binding,
ensuring that the bias
binding and the fabric edge are guided in correctly.
Quilted fabrics or several layers of fabric
should first be basted
or neatened together before binding.
Alternatively, zigzag stitch can also be used.
Here, the position should be adjusted so that,
when the needle moves to the left, it pierces
the fabric just next to the binding.


Istaknuti proizvodi